Atlas DPA-102PM 소유자 매뉴얼 - 페이지 14

{카테고리_이름} Atlas DPA-102PM에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Atlas DPA-102PM 20 페이지. Networkable 2-channel power amplifier with dsp

DPA-102PM - Networkable 2-Channel

Power Amplifier with DSP

V. Accessing the DPA via the Internet Outside the Local Network

Follow these instruction in order to access a particular DPA amplifier from outside of the Network the DPA is connected to. Example:

An amplifier is in a school in Los Angeles and the volume in the classroom is not loud enough. The installer has the maximum level

set via the limiter. Instead of the installer having to drive to the school which is 3 hours away, he can access the amplifier from his

desk or phone. During the installation of the amp, the DPA was configured with a static IP address and a specific port assigned by the

school's IT manager. This enables the installer access only to the specific DPA amplifier that needs the level adjusted. Below is a safe

convenient way to allow limited access to a specific product via a protected network. Setting up an external IP address eliminates the

requirement to VPN into a network to gain access to the LAN. This allows the person needing to maintain the device a single point of

entry and keeps the LAN secure.

1. Plug DPA amp into local network, determine the IP address assigned to the amp, and change it to a static IP address.

2. Create a NAT (Network Address Translation) on the WAN router or firewall using port 80. An external static IP address will be

needed for this process to work.

3. Once the external IP address is translated to the internal IP address, go to another Internet connection outside the Local Network

where the DPA amp is present and try connecting to the external IP address. Verify correct NAT has been established.

This link is an example of a DPA-102PM amplifier connected to a Network that allows access from the Internet. Type this link into a

web browser to access a live demonstration: http://atlasdpa102pm.atlassound.com. After connecting to the DPA amp, click the Setup

tab and enter the USER NAME (admin) and PASSWORD (admin) to gain full access of the amplifier.

Amplifier Configuration & DSP Settings

1. When the DPA GUI is accessed for the first time, the DPA Amplifier is configured as a 2-channel amplifier with the front panel

level controls active and the USER level control on the GUI page deactivated.

Note: The DPA amp Output Level can be controlled by either the front panel Level or by the GUI, but not both at the same

time. To use the GUI User Level Control, the amp needs to be configured for that operation.

2. If the DPA amp GUI is open and looks like Figure 5, the front panel level controls are active.

Notice the fader controls are invisible.

AtlasSound.com

Figure 5

1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.

Telephone: 800.876.3333 • Fax: 800.765.3435

– 14 –

Specifications are subject to change without notice.

Owner's Manual