Atlas DPA-102PM 소유자 매뉴얼 - 페이지 8

{카테고리_이름} Atlas DPA-102PM에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Atlas DPA-102PM 20 페이지. Networkable 2-channel power amplifier with dsp

DPA-102PM - Networkable 2-Channel

Owner's Manual

Power Amplifier with DSP

Installation and Considerations

Cabling

The DPA-102PM can be used with either balanced or unbalanced sources, provided the proper cabling is used. A balanced line is

defined as two-conductor shielded cable with the two center conductors carrying the same signal but of opposite polarity when

referenced to ground. An unbalanced line is generally a single-conductor shielded cable with the center conductor carrying the signal

and the shield at ground potential.

Balanced Input

Use 20-22-gauge, 2 conductor shielded wire for low level signals. Maintain the proper polarity, + to +, – to – and shield to ground.

Note: The ground center pin of the Phoenix connector is common for both channels.

Unbalanced Inputs

For the RCA inputs pre-made RCA cables can be purchased to simplify interconnection to external devices. For unbalanced signals

using the Phoenix connector connect the (–) pin of the amplifier input to the GND center pin and the (+) pin to positive.

Speaker Outputs

Use 2 conductor unshielded wire of the appropriate gauge. The DPA-102PM is approved for Class 3 wiring.

If you are unsure about this, contact Atlas Sound Tech Support at 1-800-876-3333.

1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.

Telephone: 800.876.3333 • Fax: 800.765.3435

AtlasSound.com

– 8 –

Specifications are subject to change without notice.