Atlas PM8CX 설치 지침 매뉴얼 - 페이지 2
{카테고리_이름} Atlas PM8CX에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Atlas PM8CX 7 페이지. Pedant mount loudspeakers 4" and 8"
Atlas PM8CX에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (12 페이지), 브로셔 (2 페이지), 사양 시트 (3 페이지), 설치 지침 매뉴얼 (19 페이지)
페이지 인쇄
Installation Via Mounting Cables (Included)
General considerations and hardware recommendations
CAUTION: PM series models weigh as much as 21 pounds (7.9kg) – model PM8CX. A fall from almost any height could result in serious injury
or death. Assure that the speaker is firmly mounted to an object that can handle the weight of the PM speaker. The mounting surface the PM
speaker is being attached to should be able to handle five or more times the weight of the PM speaker
The hardware employed must be safely and securely attached both to the loudspeaker and the structure in question, using only the mounting
holes. A general rule for soft surface installations (wood beams) is to multiply the corresponding working load limit by 75%: the result will be
approximate working load strength. Use thread locking compound for all installations.
CAUTION: Mounting the PM loudspeaker may require two people.
When in doubt contact a qualified structural/mechanical engineer for approval of the mounting materials and methods.
1. R emove the 3 top cover mounting screws, loosen the 2 side top cover screws rotate the top cover counterclockwise, and pull up to remove
the top cover. (Fig 1 and 2)
2. Locate suitable support structure in the area the speaker is to be installed.
3. R oute the bare end of the main support cable though the included clamp, then around the mounting structure, and back through the clamp.
(Fig 3 and 4)
4. Adjust the cable length in the clamp so that the eyelet end of the cable is at the final height above the floor. (Fig 5)
5. ( For PM8) Route the eyelet end of the main support cable through the top cover of the PM speaker, attach the included carabiner clip to
the eyelet and the large mounting hole on the back of the PM speaker. (Fig 6a) (For PM4) Route the eyelet end of the main support cable
through the top cover of the PM speaker, attach the eyelet to the large mounting hole on the back of the PM speaker using included
mounting screw. (Fig 6b)
6. R epeat steps 1-4 for the safety cable and attach it the one of the smaller mounting holes on the support plate of the PM speaker with the
included mounting screw. (Fig 6)
7. Route the speaker cable through the top cover and connect to the appropriate terminals.
8. P osition the top cover over the side cover screws and rotate the cover clockwise to align the top cover mounting screw holes. Reinstall the
3 mounting screws, tighten and tighten the side cover screws.
9. S lide the top hole plug over the main support cable, safety cable, and speaker cable using the opening on the side of the plug. Then slide
the plug down the cable and into the top cover hole. (Fig 7 and 8)
Note: If the speaker is being installed outdoors, seal plug with RTV silicone to prevent moisture from entering speaker.
1601 JACK MCKAY BLVD.
ENNIS, TEXAS 75119 U.S.A.
PM Series
Pendant Mount Loudspeakers
TELEPHONE: (800) 876-3333
FAX (800) 765-3435
2/7
AtlasSound.com