Bose 131 소유자 매뉴얼 - 페이지 7

{카테고리_이름} Bose 131에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bose 131 18 페이지. Marine loudspeaker system
Bose 131에 대해서도 마찬가지입니다: 소유자 매뉴얼 (37 페이지), 소유자 매뉴얼 (23 페이지), 서비스 매뉴얼 (7 페이지), 서비스 매뉴얼 (7 페이지), 매뉴얼 (7 페이지)

페이지 인쇄

Installation from the rear of the bulkhead

A 2

A 3

AM188201_02_V.pdf

Installing Your Speakers From The Rear Of The Bulkhead

Choose the 5

⁄

inch (13.6 cm) diameter hole size if you can comfortably hold the

speaker enclosure from behind the wall while installing screws from the front. This is

the preferred mounting method. If the hole you cut is not perfect, any slight overcut

will be hidden by the grille.

Determine that there is enough room by

A 1

reaching into the mounting area and

sweeping with your hand. Determine

where you will drill the hole for the

speaker. You should also experiment by

placing the speaker enclosure behind

the bulkhead before making your final

selection. Any orientation of the speaker

enclosure is acceptable.

CAUTION: Determine whether any

obstacles exist behind the mounting

surface. To be certain, contact your boat

manufacturer or dealer. Also, be certain

that the enclosure will fit within the mount-

ing area before drilling any holes.

The round outer edge of the template

shows how much room to allow for

the grille. The long end is used to plan

for room for the enclosure behind the

bulkhead. There are two perforated

circles in the template. Snap out the

smaller one.

Place the template over the area

where the speaker is to be located

and mark the 5

⁄

inch (13.6 cm)

hole with a metal scribing tool or

pencil.

Drill a starter hole that is large enough

A 4

for your sabre saw blade. Be sure to

drill inside and close to the line you

have marked.

October 30, 2001