Atlas Copco PBE 6 S 수리 지침 - 페이지 8
{카테고리_이름} Atlas Copco PBE 6 S에 대한 수리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Atlas Copco PBE 6 S 11 페이지.
페이지 인쇄
Assembly
1
Mounting the
Press the needle bearing (2) into the con-
cylinder and the
necting rod (1).
connecting rod
2
Push the percussion body (A) and the
gasket (9) into the cylinder (8).
3
Put together the cylinder (8) and the con-
necting rod (1) and push the cylindrical
bolt (7) through both borings.
4
Insert the cylinder (8), the washers (3
and 4) and the holder (5) into the gear
housing (6).
1
Mounting the
Insert the O-ring (6) into the gear hous-
crankshaft
ing (C).
2
Press the ball bearing (4) onto the crank-
shaft (5).
3
Insert the crankshaft (5) into the gear
housing from below (C) and fit it to the
connecting rod bearing.
4
Mount the spring ring (3).
5
Insert the key (D) into the crankshaft (5).
6
Fit the crank wheel (2) with the collar fac-
ing the eccentric and press it on.
7
Secure the crank wheel (2) with the spring
ring (1).
8
If necessary, mount the welch plug (7).
9
Fill the gear housing (C) through the serv-
ice opening with grease according to the
lubrication chart.
10
Fit the service cover (8) with gasket (B)
and valve (9) and fasten it with the
screws (A).
Steady the crankshaft with a suitable
mandrel which is pushed through the
opening in the cover (otherwise the
crankshaft is pushed in too far).
Repair Instructions No.182.03/98
2
1
7
PBE 6 S
3
4
5
6
7
A
9
8
A
9
8
B
C
7
6
5
D
4
3
2
1
PAGE
7
1
2