Atlas fan company DIANE 소유자 매뉴얼 - 페이지 4

{카테고리_이름} Atlas fan company DIANE에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Atlas fan company DIANE 4 페이지.
Atlas fan company DIANE에 대해서도 마찬가지입니다: 사용자 설명서 (2 페이지), 사용 설명서 (10 페이지)

페이지 인쇄

FINISHING THE INSTALLATION:

1. Make sure the tab at the bottom of the hanging

bracket is properly seated with the groove in the

hanger ball. Failure to properly seat the hanging ball

could cause damage to wiring and the fan.

2. Slide the canopy up to the ceiling and over the two

screws on the hanging bracket. Rotate the canopy

clockwise and tighten the two screws to secure.

3. Slide the canopy cover over the two screws and

rotate clockwise until tight. You may need to adjust

the canopy screws as necessary until the canopy and

canopy cover are snug.

NB: The canopy screws must be tightly secured to

maintain earthing continuity.

CARE OF AND TROUBLESHOOTING YOUR FAN:

Check hardware every 6 months: Because of the fans mechanical movement, some

•

connections may become loose over time. Check the support connections, brackets and

blade attachments twice a year to make sure they are secure. It is NOT necessary to remove

the fan from the ceiling .

Clean your fan periodically: Cleaning will help maintain your new fans appearance over the

•

years. Use ONLY a lightly water moistened, lint free cloth to avoid scratching the finish.

Plated finishes are sealed with lacquer to minimise discolouration or tarnishing. Do NOT let

rain or running water to come into contact with the fan, as this could damage the motors of

the fan, timber blades, or possibly cause an electric shock.

There is no need to oil the fan: The motors of your fan have permanently lubricated

•

bearings, so no additional lubrication is required.

Fan makes a vibration noise: Check to ensure that all screws are tight, especially the

•

connection of the fan cages to the motor face plate.

Fan actually vibrates: Uninstall and reinstall the blades. Make sure that the fan heads set

•

screw is counter sunk into the bore hole in the flat part of the motor shaft. (Refer Step 5 &

10 in section "Mounting/Installation of the Fan") Be careful that the blade brackets

themselves are not bent in the process. Do not operate the fan if it continues to vibrate,

contact the Atlas warranty line if reinstallation of the blades does not resolve the problem.

Fan oscillation is irregular or not smooth: The decorative motor mounts are meant to

•

swivel with the oscillation of the fan. This movement is important! If the oscillation is

irregular and not smooth, it could be that your decorative knobs are too tight, touching the

yoke and not permitting the oscillation of the motor to operate properly. Loosen the knobs

slightly so that the knob is not touching the yoke assembly. As a rule of thumb, you should

have about 1mm clearance between the knob and the yoke assembly. Do NOT loosen the

knob too much, doing so will cause it to fall off during operation of the fan.

Distributed by: Prestige Fans Pty Ltd

PO Box 5050 Ringwood VIC 3134