Atlas fan company Irene YG432-MG 설치 및 사용 설명서 - 페이지 6

{카테고리_이름} Atlas fan company Irene YG432-MG에 대한 설치 및 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Atlas fan company Irene YG432-MG 12 페이지. 52" ceiling fan

5. Loosen the two set screws and remove the

hitch pin and lock pin from the central

shaft/top coupling of the motor assembly.

Doing so will allow the down rod to enter

the central shaft. (Fig.9)

6. Carefully feed the fan wires through the

down rod and pull them taught. Place the

down rod into the central shaft and tighten

with the lock pin and hitch pin previously

removed, re-tighten the set screws against

the downrod.

7. Slide the coupling cover (with wide end

oriented to the floor) down the down rod.

8. Slide down the secure ring, and fasten

using the Allen wrench provided.

9. Slide canopy cover (with decorative side

oriented to the floor) and canopy (with wide

end oriented to the ceiling) onto the down

rod. Carefully reinstall the hanger ball onto

the rod. Be sure that the cross pin is in the

correct position, the set screw on the

hanger ball is tight and that the wires are

not twisted.

10. Now lift the motor assembly (fan with

blades) into position and place the hanger

ball into the hanger bracket. Rotate the

down rod until the "Check Tab" has dropped

into the "Registration Slot" and the down

rod and ball assembly seat firmly. The down

rod and ball assembly should not rotate if

this is done correctly. (Fig.10)