Bose PDF256950 소유자 매뉴얼 - 페이지 13
{카테고리_이름} Bose PDF256950에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bose PDF256950 40 페이지. 3 - 2 - 1 home entertainment system
페이지 인쇄Making
the connections
Labeled jacks on the rear of the media center (Figure 8) and the custom cables supplied with
the Model 3.2.1 system make it easy to get everything hooked up right the first time.
Figure
8
Connection panel on the
rear of the media center
Y
I
Figure 9
Completed connection of
speaker cable to media
center rear panel
Follow
these
basic
steps
1.
On the rear panel of the media center, insert the single-plug end of the speaker cable into
the SPEAKERS connector (Figure 8). Tighten the screws on either side of the plug (Figure
9).
Note: Using the screws on the plugs will ensure a snug connection.
When properly inserted,
there will be a small gap between the plug and the panel.
Figure
10
LEFT and RIGHT markings
on the speaker connectors
.
.
P
Screws
At the other end of the speaker cable, pull the cable apart to separate the two connectors
as much as necessary to reach each speaker.
Plug the LEFT connector of that separated cable into the rearjack on the left speaker
(which will be left of the TV as you face it) and the RIGHT connector into the rear jack on
the right speaker (right of the TV). LEFT or RIGHT is printed on the appropriate
connec-
tors (Figure 10).
.
On the Acoustimass
module, insert the right-angle connector (Figure 11 on page 14) of
the Acoustimass
module cable into the jack labeled MEDIA CENTER. On the rear panel
of the media center, insert the other end of that cable into thejack
labeled ACOUSTI-
MASS MODULE. Firmly tighten the two screws at each end.
September 21, 2001
PDF256950 Rev. 01
13