advanced scale models DeHavilland DH88 Comet 사용 설명서 - 페이지 3

{카테고리_이름} advanced scale models DeHavilland DH88 Comet에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. advanced scale models DeHavilland DH88 Comet 8 페이지.

STEP 1:

Trial fit the tailplane to the fuselage and mark where

the area of covering will need to be removed to

expose the wood and enable the glue to adhere

properly. Carefully cut through the film covering

inside the marks - ensuring that you do not cut into

the wood sheeting.

STEP 2:

Make a groove in the tailplane for the

pre-assembled elevator joiner/control

horn to rest.

STEP 3:

Using a sharp knife or a

round file, make a small

notch in the fuselage to

clear the elevator joiner

and the rudder/tailwheel

assembly.

STEP 4:

Connect the elevator

pushrod to the elevator

joiner/control horn and

fit into position in the

fuselage.

STEP 5:

Connect the rudder/tailwheel pull/pull

cables to the assembly then slide the

tailplane in position. Before gluing the

tailplane in position, make sure that is

correctly aligned in relation to the wing.

STEP 6:

Now run a small bead of

medium CA around the

outside tailplane/fuselage

joint. This will prevent glue

running onto the tailplane

covering when applying

medium CA adhesive to the

inner joint.

_____ Page 3 _____