Alert-it Care Systems P163ACB 핸드북 - 페이지 4

{카테고리_이름} Alert-it Care Systems P163ACB에 대한 핸드북을 온라인으로 검색하거나 PDF를 다운로드하세요. Alert-it Care Systems P163ACB 10 페이지. General alarm monitor

Installation (cont)

Sensor Testing

Occupancy Sensors

Ensure the bed/chair is unoccupied and after pressing RESET there will be a four

tone beep and the unit should be in STANDBY. Five tones will indicate the sensor

is being falsely triggered by the weight of the bedding/cushion or otherwise in-

stalled incorrectly.

Activate the sensor and a single beep should be heard indicate successful detection

of the occupant. After that operation is silent.

Deactivating the sensor will then raise the alarm, either instantly or after the delay

period (it is not essential to wait for this as the above proves the senor operation).

Reset the unit to stop further nuisance alarms

Switch Sensors

After RESET there should be no alarm. Activate the sensor and check an alarm is

raised. There is an optional beep when the sensor is activated (i.e. usually for

switch inputs but not for floor mats).

These tests should be performed regularly to confirm correct system operation

All parts of the system, apart from the pager charger, are suitable for use within the patient vicinity

Operation

The monitor is turned on by

Ÿ Removing the power key for battery power

Ÿ Connecting a mains adapter if required

Ÿ Or its is always available if the rechargeable battery has

been fitted and enabled

Operating the P163:

Call for Assistance (all versions)

Activating the call button for longer than 1 second will result

the Nurse Call being activated.

P163BAB Bed/Chair Vacation

After power-up (or RESET) the monitor will be in STANDBY. When the

Occupancy sensor is activated there will be a beep (default) and the monitor will

become active. When the user leaves the bed/chair, the monitor will activate the

Nurse Call (either immediately or after a time delay dependent on the "1-Input

UH1142B P163 Wired General Interface v2 page 4 of 8