Absima 2130042 빠른 시작 매뉴얼

{카테고리_이름} Absima 2130042에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Absima 2130042 3 페이지. Competition team motor

Absima « Reve

Thank you that you have chosen a product of the "Revenge CTM" series. Here you get a high quality competition

Please read the instructions carefully. By using this product you agree to the terms of the warranty of Absima

Make sure that the motor temperature does not exceed 80°C, fit the reduction ratio of the engine when it is too hot

mounting the motor, pay attention tot he correct length of screws and not to over tight them with to excessive torque force.

The screws should not protrude more than 5mm in the motor housing as this could damage the motor winding.

Damage caused by excessively long screws will not be covered by the warranty.

Please note that the solder connections are marked A, B and C and connect the motor to the controller as described. During the

soldering process, ensure that the connections are not shorted by solder to each other.

Clean your Revenge Motor regularly in the area of ball bearings with brush and oils tot he ball bearings with suitable ball bearing

By the gear ratio you can see based on the temperature if the engine is operating effectively, the temperature should never

exceed 80°C. Approach slowly to the right gear ratio to avoid damage of the motor.

On the side of the motor is a scale where you can see the position of the timing. By loosening the rear screws you can twist the

An increase of the timing brings automatically an increase of the temperature. This depends on both, the timing that is on the

motor, as well as the timing, which is simulated with the controller. Please make sure that you be very careful with the

Approved for:

Part no.:

Turns:

RPM-V:

Power:

Current A:

Efficiency:

Voltage:

Poles:

Sensor:

Adjust. timing:

Ø w/o fins:

Shaft diameter:

(Competition Team Motor)

product, developed by racers for racers, to win races.

Precautions & Warnings

Read these instructions carefully before using your new motor!

Cleaning & Maintenance

Gear Ratio & Timing

adjustment of the timings etc.

Technical Information

2130040

2130044

1750 KV

1900 KV

1750

1900

1670W

1850W

110A

120A

88%

4-6S

4 Pole

GmbH.

Assembly

oil.

timing shield

Attention:

1:8 Scale*

2130041

2130042

2100 KV

2300 KV

2100

2070W

2100W

125A

88%

4-6S

4 Pole

Yes

42mm

5mm / Module 1

2130043

2500 KV

2300

2500

2650W

145A

160A

88%

86%

4-6S

3-4S

4 Pole

When