3M XT-1 기술 게시판 - 페이지 2

{카테고리_이름} 3M XT-1에 대한 기술 게시판을 온라인으로 검색하거나 PDF를 다운로드하세요. 3M XT-1 10 페이지. Drive-thru systems
3M XT-1에 대해서도 마찬가지입니다: 빠른 참조 매뉴얼 (6 페이지), 빠른 참조 매뉴얼 (2 페이지), 기술 데이터 (2 페이지), 기술 게시판 (2 페이지), 빠른 시작 매뉴얼 (3 페이지), 매뉴얼 (8 페이지)

Replacing the Ear Cup and/or Ear Pad and/or Head Pad and/or Microphone Windscreen

Replacing the Ear Cup and/or Ear Pad

Tools Required: None

3M OEM Parts and SKUs:

Procedure:

1. To replace the ear cup or ear pad, use your fingers to twist and pull the ear cup

and ear pad together, from the speaker on the headset case.

2. Gently separate the ear pad from the ear cup.

Replace the damaged ear pad and/or ear cup with a new one and reassemble.

3. Align the assembled ear cup and ear pad with the headset speaker, then

twist and press into place.

Replacing the Head Pad:

Tools Required: None

3M OEM Parts and SKUs:

Procedure:

1. To replace the head pad, use your fingers to peel the old pad away from the battery case.

Clean off all adhesive residue remaining on the surface.

2. Remove the protective backing from a new self-adhesive head pad and

press into place on the inside surface of the battery case.

Replace Microphone Windscreen on the headset

Tools Required: None

3M OEM Parts and SKUs:

Procedure:

1. Remove the old microphone windscreen from the headset.

2. Install the replacement microphone windscreen from the manager's kit by stretching the opening

of new windscreen and slide over Microphone.

Ear Pad

Ear Cup

Headset Speaker

FIGURE 1

Head Pad

FIGURE 2-a

FIGURE 2-b

Microphone Windscreen