Annovi Reverberi AR 303 사용 설명서 - 페이지 11

{카테고리_이름} Annovi Reverberi AR 303에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Annovi Reverberi AR 303 19 페이지.

Pump Storage

It is important to comply with the recommendations for storage in the operator's manual of the machine

into which the pump is incorporated.

For the pump itself, at the end of pumping operations it is essential to flush out the internal circuit by pump

ing clean water. After this, open the intake circuit to the air and leave the pump in operation until the internal

circuit is completely empty. Following this simple procedure at the end of every operating session will prevent

the retention inside the pump of products which are often corrosive and may damage its liquid circuit over

the long-term.

If the pump is in storage during the winter in locations with severe weather conditions, it is very important to

flush out the internal circuit as described above and then fill the pump with A/R Pump Saver, AR64511. Then

take care to drain the liquid from the system and the pump.

Putting the pump back into service

Before putting the pump back into service after storage, check the oil level and the tightness of the

mounting screws.

Scrapping the pump

Used units must be disposed of in compliance with local legislation.

A/R Pump Saver

P/N 64511

Protects Pumps from Freezing Conditions