3M 725 사용자 설명서 - 페이지 12

{카테고리_이름} 3M 725에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3M 725 16 페이지. Wrist strap monitor
3M 725에 대해서도 마찬가지입니다: 사용 설명서 (15 페이지)

Equipment Needed

• Resistance Substitution Box (RSB), 1 Ohm to 45 Megohms ± 1%.

• One two-conductor cable with standard 3.5 mm (miniature) phone plug attached

on one end and appropriate connectors on the other end to connect to RSB.

• Two single conductor wires with clip style on one end and appropriate

connectors on the other end to connect to a RSB.

Note: Two conductor cables must have an isolation resistance of >1 Gigohm between conductors.

Two separated wires may also be used to obtain higher isolation resistance.

Procedure

a) Install a new 9 volt battery into the 3M

b) Short the dual conductor ground clip by attaching to a conductive metal

object such as a coin.

c) Plug the phone jack test cord into the wrist strap jack on the front of the

monitor and attach the other end of the cord to the RSB.

Set the RSB as follows and observe the lamp and audible alarm:

29.8 Megohms – Red lamp OFF, audible alarm OFF.

•

40.2 Megohms – Red lamp ON (Flashing), audible alarm ON

•

(Chirping).

d) Connect the two single conductor wires to the RSB. Attach the other ends

of the wires with clips to the metal jaws of the Wrist Strap Monitor Model

725 dual conductor ground clip. Be sure to prevent the clips from contacting

each other. Plug in the phone jack test cord into the wrist strap jack on the

front of the monitor and short the opposite ends together.

Set the RSB as follows and observe the lamp and audible alarm:

5.0 Megohms – Red lamp OFF, audible alarm OFF.

•

11.5 Megohms – Red lamp ON (Continuous), audible alarm ON

•

(Continuous tone).

Wrist Strap Monitor Model 725.

™