Anova TP2502 사용자 설명서 - 페이지 6

{카테고리_이름} Anova TP2502에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Anova TP2502 12 페이지. Battery pruning shears

3. Use and maintenance

3.1 Commissioning

1. Remove the machine from the packaging. Install the lithium battery, press and hold the power switch

for three seconds, and then release it. You should hear the sound of two beeps; this means the battery is

normally charged.

2. Press the trigger continuously and quickly twice to open the blade automatically.

3. Before starting work, press the trigger to operate the blade several times and listen for any unusual

noises or too fast or too slow working speed. If everything is normal, you can start working.

4. Power off: press the trigger and release it after hearing a beep twice. The blade will close

automatically.

3.2 Tips for use

Note:(1) The machine may overheat after continuous use, this is a normal phenomenon. Let the

machine cool down for a while and you can use it again when the temperature drops.

(2) After pruning work is completed, at the end of the season, or when you replace the blade, and need

to remove the blade, add lubricating oil for maintenance of the blade and cutting system.

While you are pruning, start pruning about 8mm from the shoot; the maximum cutting

diameter is 25mm.

Prune away from the shoot to prevent sap loss from the plant.

Do not prune branches too far from the tree as this will reduce the health of the plant.

Leave a small stretch of the branch to avoid stressing the plant.

While working with the scissors, keep your hands away from the cutting blades and wear

suitable gloves and protective gear.

Remove diseased shoots and remove dry branches on the plant.

When pruning on a tree, prune each branch separately and do not cut multiple branches

at once.

3.3 Battery charging

The battery of a new machine is not fully charged. Before

charging, insert the battery into the charger and insert the plug of the

charger into the wall outlet. The "+" of the battery must be inserted into

the "+" of the charger, as shown in the picture on the right. The indicator

light on the charger will show green once it is fully charged. Always use

the battery after full charges.

3.4 Special attention

1. Before charging, please turn off the switch; During charging, it is normal to have a slightly warm

charger and batteries.

2. If the batteries are not used for a long time, they should be recharged every 3 months to increase the

service life;

3. New batteries or batteries not used for a long time will reach full capacity after 5 times of charge-

discharge cycles;

4. Please do not charge the batteries repeatedly after several minutes of operation, this may reduce the