3M Dynapro ET 350L3 설치 매뉴얼 - 페이지 2

{카테고리_이름} 3M Dynapro ET 350L3에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3M Dynapro ET 350L3 6 페이지. Nema 4x hatch
3M Dynapro ET 350L3에 대해서도 마찬가지입니다: 설치 매뉴얼 (7 페이지)

페이지 인쇄

Equipment

Materials supplied

The following materials are supplied for installing the

NEMA 4X hatch:

1 NEMA 4X hatch (with removable plate attached).

1 NEMA 4X extended hatch cover

1 gasket

4 #6-32 Phillips screws

Cable fitting components (3 large sizes and 3 small

sizes of each component are provided):

Locking nut

O-ring

Body hex with compression sleeve

Sealing nut

3M Touch Systems Proprietary Information

For details about the supplied cable fitting

components, see Table A.

Tools required

To install the NEMA 4X hatch, you will need the

following:

Horizontal work surface with a padded cover or foam

pads to protect the front bezel and the display of the

unit.

Flat blade screwdriver with 3/16-inch blade

No. 1 Phillips torque screwdriver

1 19/32" (15 mm) open-end wrench

1 15/16" (24 mm) open-end wrench

Attaching the gasket

Important

If you ordered the ET 350L3 monitor, the hatch gasket was

attached at the factory. Proceed to "Preparing the hatch for

cables".

1. Place the ET unit face down on a horizontal work

surface (covered with foam pads or other material to

protect the unit's bezel and touch screen), with the

access hatch facing you.

2. Before removing the gasket backing, position the

gasket over the recessed edge of the access hatch

opening so that you know which way it fits.

Installing the NEMA 4X Hatch