DS Stoves FP16 소유자 매뉴얼 - 페이지 7

{카테고리_이름} DS Stoves FP16에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DS Stoves FP16 13 페이지. High efficiency hopper fed coal insert

Assembly Diagram

Blower Instructions

On the front lower right corner you will find a speed con-

troller. This is where you can turn blower off and on or

choose the speed of your blower. NOTE: Never turn blow-

er off while insert is in operation.

If your blower needs serviced or replaced

there are two ways of accomplishing this.

Access through firebox.

• Clean out firebox.

• Remove two back brick on left side of firebox. Remove

back row of firebrick, 11 gauge SS heat shield and the

blanket insulation.

• Take the 12 bolts out of blower cover plate located at the

back of firebox. Pull blower right into the firebox.

Disconnect wiring and remove blower from insert.

Access from back of unit

• Remove blower access panel from back of unit.

• Remove 4 bolts that hold blower in place.

• Pull blower straight out the back of unit. Disconnect wiring

and remove blower from insert.

Blower Plate

Power cord can be left

or right side of insert.