DSC PC3000RK 사용 설명서 - 페이지 3

{카테고리_이름} DSC PC3000RK에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DSC PC3000RK 15 페이지.

Master Code

The 4 digit Master Code is used for arming and disarming the system, for

programming additional access codes, and for changing other features. The

Master Code will be supplied to you by your installer. All keypad entries are made

by pressing one key at a time and may be changed by you at any time if the installer

selects an option. For additional access codes, see Programming Additional

Access Codes.

Close all protected doors and windows and stop movement in areas covered by

motion detectors. If the "Bypass" light is ON, be sure zones are being intentionally

bypassed before arming the system (see Zone Bypassing).

Check to see that the "Ready" light is ON (all zones are closed). The system cannot

be armed unless the "Ready" light is ON. Enter a [4 digit access code]. As each

digit is entered, the keypad sounder will beep. Once the correct access code is

entered, the "Armed" light will come ON and the keypad sounder will beep quickly.

If the access code was entered incorrectly or the "Ready" light was not ON, the

keypad sounder will beep steadily for 2 seconds.

When the correct code is entered and the system is armed, exit through the door

indicated by your installer as the exit-entry door. The exit time may be changed by

your installer (please refer to the Quick-Arm feature).

This feature, if selected by your installer, will allow you to arm your system with any

valid access code and the system will automatically bypass the interior zones if

those interior zones have been designated as home-away zones by the installer.

When activated, the "Bypass" light will come ON. If you exit within the allowed exit

time, the system will automatically reactivate the interior zones. This feature is

designed to save the user from having to manually bypass interior zones each time

they wish to arm the system and remain at home.

In residential applications where the system has been armed and the interior zones

are automatically bypassed, the interior zones can be reactivated from a keypad

outside the interior zones protection area (e.g. a bedroom). To reactivate the interior

zones, press [

If you wish to arm your system and eliminate the entry delay, enter [

your access code. The "Armed" light will flash as a reminder that the system is

armed and has no entry delay. An entry through any zone programmed as a delay

zone will create an instant alarm.

] then [1] and the "Bypass" light will go out.

],[9] before