ATTO Technology UL4D PCI 문제 해결 매뉴얼 - 페이지 4
{카테고리_이름} ATTO Technology UL4D PCI에 대한 문제 해결 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ATTO Technology UL4D PCI 12 페이지. Atto technology ul5d lp host adapters: supplementary guide
ATTO Technology UL4D PCI에 대해서도 마찬가지입니다: 호환성 차트 (1 페이지), 보충 설명서 (8 페이지)
페이지 인쇄
The computer's BIOS scan recognizes the UL5D host adapter, but only detects
connected SCSI devices on one of the busses. The other bus reports no devices.
Swap the devices
the one having issues. If the issue follows the bus, replace the SCSI host
adapter.
If the issue follows the attached SCSI devices, troubleshoot the attached
devices:
Verify the SCSI devices are powered on.
Check the SCSI devices to make sure that they are all set to different SCSI ID's.
Each device on each SCSI bus must use a unique ID, including the host adapter.
Devices on Bus 1 can have the same IDs as those on Bus 2. By default, the host
adapter uses SCSI ID 7, so devices should use ID's 0 through 6, or 8 through 15.
Check cable integrity. Check the cables for solid connections. Make sure they
are screwed down. Inspect cable ends for bent pins. U320 SCSI requires high
quality cables that are specifically rated for the U320 transmission speeds.
Boot into Windows and use the ATTO Configuration Tool to verify the host
adapter has its termination set properly. Instructions to do this can be found in
the help portion of the ATTO Configuration Tool.
Verify the external terminator is the same SCSI type as the devices (certified as
usable for Ultra320 SCSI or lower) and does not have damaged pins.
Try attaching SCSI devices one at a time with different cables, adding drives and
cables until the problem occurs. This will help pinpoint the device or cable
causing the problem.
Watch the LED indicators on the SCSI devices before, during, and after startup.
Drive lights should also flash at startup as the SCSI bus is scanned. This may
give a clue as to the root cause of the issue.
The UL5D host adapter is detected during the system's BIOS scan but it is not
detected by the operating system.
Note: When working properly, the UL5D host adapter will show up in the device
manager.
Page 4 of 12
and cables
from the SCSI bus that appears to be working with
Atto Technology, Inc.
January 19, 2007