ATV IPVD3RWI 빠른 매뉴얼 - 페이지 12

{카테고리_이름} ATV IPVD3RWI에 대한 빠른 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ATV IPVD3RWI 16 페이지. 3mp vca vp dome network camera

2.2 Connection

• Micro SD memory card insertion

Remove the bubble of the camera to insert the SD memory card.

• Connecting to the RJ-45

Connect a standard RJ-45 cable to the network port of the network camera. Generally

a cross-over cable is used for directly connection to PC, while a direct cable is used for

connection to a hub. You can also use a router featuring PoE (Power over Ethernet) to

supply power to the camera.

• Connecting Alarms

AI(Alarm In): You can use external devices to signal the network camera to react on

events. Mechanical or electrical switches can be wired to the AI (Alarm In) and G

(Ground) connectors.

G(Ground): Connect the ground side of the alarm input and/or alarm output to the G

(Ground) connector.

AO(Alarm Out): The network camera can activate external devices such as buzzers

or lights. Connect the device to the AO (Alarm Out) and G (Ground) connectors.

• Connecting the Power

Connect the power of 12 VDC 450mA for the network camera. Connect the positive

(+) pole to the '+' position and the negative (-) pole to the '-' position for the DC power.

– Be careful not to reverse the polarity when connecting the power cable.

– A router featuring PoE (Power over Ethernet) can also be used to supply power to

the camera.

– For the power specifications, refer to the Appendix, Product Specification.

– If PoE and 12 VDC are both applied, the camera will be supplied with power from

PoE.

• Connecting Audio

Connect Speaker to Audio line output and external Mic to Audio input line.

SD memory card