ATV NVW2212M 빠른 매뉴얼 - 페이지 8

{카테고리_이름} ATV NVW2212M에 대한 빠른 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ATV NVW2212M 12 페이지. Vp dome network camera

2.2 Connection

•

Micro SD memory slot on the Bottom Board

Remove the cap at bottom of the camera to insert the SD memory card.

•

Connecting to the RJ-45

Connect a standard RJ-45 cable to the network port of the network camera. Generally a cross-over

cable is used for directly connection to PC, while a direct cable is used for connection to a hub. You

can also use a router featuring PoE (Power over Ethernet) to supply power to the camera.

•

Connecting Alarms

AI(Alarm In): You can use external devices to signal the network camera to react on

events. Mechanical or electrical switches can be wired to the AI (Alarm In) and G (Ground)

connectors.

G(Ground): Connect the ground side of the alarm input and/or alarm output to the G (Ground)

connector.

AO(Alarm Out): The network camera can activate external devices such as buzzers or lights.

Connect the device to the AO (Alarm Out) and G (Ground) connectors.

•

Connecting the Power

Connect the power of 12VDC for the network camera. Connect the positive(+) pole to the '+' position

and the negative (-) pole to the '-' position for the DC power.

–

Be careful not to reverse the polarity when connecting the power cable.

–

A router featuring PoE (Power over Ethernet) can also be used to supply power to the

camera.

–

For the power specifications, refer to the appendix, product specification.

–

If PoE and 12 VDC are both applied, the camera will be supplied with power from PoE.

•

Connecting Audio

Connect speaker to audio line output and external Mic to audio input line.

•

Connecting Test Monitor Out(CVBS)

Connect 3pin test video cable(Optional) to check test video.