AddEnergie SmartTWO 설치 매뉴얼 - 페이지 19
{카테고리_이름} AddEnergie SmartTWO에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AddEnergie SmartTWO 20 페이지.
AddEnergie SmartTWO에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (4 페이지)
페이지 인쇄Preliminary Tests & Commissioning
2
2
3
1
2
1
201304-AAA-001
201304-AAA-001
2
2
3
1
© 2019 ADDÉNERGIE TECHNOLOGIES INC. ALL RIGHTS RESERVED Information and specifications contained in this document are subject to change, amendments and additions at any time, without notice
Instructions:
1.
Place the charging port in the holder and close the door.
2.
Once the charging station is powered up, check the following:
2.1. The door is locked.
2.2. The charger head status lights turn to GREEN.
2.3. The display shows the greeting messages.
3
1
3.
Swipe the card provided with the charger in front of the
2
3
display.
The charger will react as follows:
3
1
3.1. Once the reader detects the card, it will emit an audible
beep.
3.2. The access card is authenticated by the charging station.
3.3. If the test is successul, the charger head status WHITE
lights will start flashing and the charging port will be
unlocked.
3.4. If the charging port is inserted into an Electrical Vehicle,
it will begin charging. If not, 1 minute later, the charging
session will be cancelled.
4.
If the preliminary test is successful:
4.1. Make sure you have installed the Communication
Gateway according to the instructions described in the
"Important" section, on page 2 of this guide.
4.2. Call AddEnergie for charger commissioning:
3
1
2
3
1
2
3
1
2
4
877-505-2674
2
3
1
2
3
1
2
3
3
1
4
1
19