Auber Instruments WS Series 빠른 매뉴얼 - 페이지 9

{카테고리_이름} Auber Instruments WS Series에 대한 빠른 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Auber Instruments WS Series 15 페이지. Programmable pid temperature controller with dual probe
Auber Instruments WS Series에 대해서도 마찬가지입니다: 빠른 매뉴얼 (14 페이지), 작동 및 사용 설명서 (18 페이지), 작동 및 사용 설명서 (18 페이지), 빠른 매뉴얼 (14 페이지)

페이지 인쇄

hours, waiting you to pick the food. If you set C-3=0 and t-3=0, when meat internal

temperature reaches 160 °F, the controller will shut off the heater, flashing END on both

windows, and turn on the beeping alarm to notify you that cooking is finished.

Table 1. Initial program setting

Step #

C-1

C-2

C-3

C-4

C-5

C-6

The smoker generator power is controlled by parameter R1 and R2 that can be

accessed by code 166 (see section 7). The generator can be turned on for two steps. R1

is for the first step. R2 is for the second step. e.g. To turn on the smoker generator at step

1 and 3, set R1=1 and R2=3. If you only want to use one step, set either R1 or R2 to 0,

and set the other one to the step you want to turn on the smoker generator. The initial

setting for the controller is to turn on the generator at step 1 only.

4. Check the current step and display the time

To check which step the program is at during cooking, press the "+" Key (8) once. The

left window will show the current step in the form of P0X on. e.g. It will display P03 if the

controller is at step 3. The display will return to the temperature display automatically

after 8 seconds. To check how long the controller has been running since powered up,

press the Time key (9) once. The Timer status indicator will light. The right window will

show the actual time passed since the controller was last powered up. Please note that

this is the total time, not the time that has passed in the current step. Press Time key

again will switch the display to the internal temperature.

5. Tuning the controller

This controller contains two sets of system parameters that can be changed for different

applications. This controller is shipped with the system parameters set for the Bradley

Smoker. The user should not change these parameters if you want to control a Bradley

Smoker. Otherwise, if you feel that performance is not ideal, you can try to manually tune

the system or run the auto-tune again. For detailed information on how to tune the

controller, please read the section 7 and 8 of the main manual.

Temp (F)

Step #

120

E-1

190

E-2

130

E-3

E-4

E-5

E-6

F or T

Step #

t-1

F-2

t-3

t-4

t-5

t-6

value

2.0

160

30.0

0.0