Auber Instruments WS Series 빠른 매뉴얼 - 페이지 4

{카테고리_이름} Auber Instruments WS Series에 대한 빠른 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Auber Instruments WS Series 15 페이지. Programmable pid temperature controller with dual probe
Auber Instruments WS Series에 대해서도 마찬가지입니다: 빠른 매뉴얼 (14 페이지), 작동 및 사용 설명서 (18 페이지), 작동 및 사용 설명서 (18 페이지), 빠른 매뉴얼 (14 페이지)

페이지 인쇄

cabinet temperature. We name it probe 1. It needs to be plugged to the top sensor jack

at the back of the controller. The long probe with a bend at the end is for the meat

internal temperature measurement. It needs to be plugged to the bottom sensor jack at

the back of the controller. The tips of the probes are dropped into the damper hole. Place

a piece of tape on the top of the smoker tower to hold them in place. The tip of probe 1

should be placed close to the food but high enough so that it does not touch the food.

(See Error! Reference source not found.). The tip of probe 2 is to be inserted into the

meat.

Figure 3. Sensor position. Left, the sensor should be placed close to the food but high

enough so that it does not touch the food. Right, hold the sensor in place by a piece of

tape.

For the "Original" and Stainless Steel Bradley smoker, the Temperature Heat Control

Switch on the smoker tower should be slid to the Hi position (Most right).

There are several ways to power up the controller and Bradley Smoker.

Figure 3.1 Power Cable wiring for Original Bradley Smoker

Cable A: Power cable for Smoker Tower, C14 plug