Auber Instruments SYL-1813-MR 사용 설명서 - 페이지 3

{카테고리_이름} Auber Instruments SYL-1813-MR에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Auber Instruments SYL-1813-MR 3 페이지. Multifunction automotive gauge

AUBER INSTRUMENTS

Figure 6. Wiring SYL-1813-MR with an EGT probe and an alarm buzzer.

E.2 Pressure transducers

Here is a brief description of how to set up the gauge for reading an Auber-103,

3 Bar MAP Sensor.

a) Identify the power, signal, and ground wires on the pressure sender (please

refer to the manual of pressure sender). Connecting power cable to terminal 10,

signal cable to terminal 9, and ground cable to terminal 6.

b) To display the pressure in bar (with 0.01 bar resolution), enter the Basic

Parameter Setting Mode using access code 0089, change the input type Inty to

"5v" input (5v), then set dot = 00.00, PuL = 00.01, and PuH = 03.15.

c) To display the pressure in PSI (with 0.1 PSI resolution), enter the Basic

Parameter Setting Mode with access code 0089, change the input type Inty to

"5v" input (5V), then set dot = 000.0, PuL = 000.2, and PuH = 045.7.

E.3 Water/oil temperature sensor

If a VDO 150° C/300° F sender is used to read water/oil temperature, here is the

basic settings.

a) Connect the VDO sender to terminal 8; jump a wire between terminal 6 and 7;

jump another wire between terminal 2 and 6.

b) Enter the Basic Parameter Setting Mode using code 0089; set input type

Inty = vdo; and set CorF to "C" or "F" for desired temperature unit.

Auber Instruments Inc.

5755 North Point Parkway, Suite 99,

Alpharetta, GA 30022

www.auberins.com

Tel: 770-569-8420

No part of this datasheet shall be copied, reproduced, or transmitted in any

way without the prior, written consent of Auber Instruments. Auber Instruments

retains the exclusive rights to all information included in this document.

2021.05

Power

12VDC

+ TC -

WWW.AUBERINS.COM

P3/3