Anyload EC200 운영 매뉴얼 - 페이지 12

{카테고리_이름} Anyload EC200에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Anyload EC200 16 페이지.
Anyload EC200에 대해서도 마찬가지입니다: 사용자 설명서 (8 페이지)

페이지 인쇄
Anyload EC200 운영 매뉴얼
Besides performing accurate simple weighing, your versatile weighing machine can also perform

pieces counting

4.2.1 Pieces counting
4.2.1.1 Counting pieces with known sample unit weight
-
Turn scale on
- Wait for "0" to appear on the display.
- If necessary, press ZERO key to set the display to "0"
- Key in unit weight, press UNIT WEIGHT key to confirm
-Store the unit weight by pressing MEM/STORE key, display will show a flashing number for
example "01", this is the location where the stored sample unit weight can be found. Press [*]
key to toggle between 01-16, press the ENTER key to confirm the selection.
- Press the SCALE/SELECT key to select either SCALE 1 or SCALE 3, be sure to place
the additional pieces on the scale that is selected.
***NOTE: The items being weighed should be within the selected scales capacity.
4.2.1.2 Counting pieces without known sample unit weight
-
Turn scale on
- Wait for "0" to appear on the display.
- If necessary, press ZERO key to set the display to "0"
- Press SCALE/SELECT key to select SCALE 2, press ENTER to confirm
-Put a pre-known number of samples onto SCALE 2, key-in the known number using the
numeric keypad.
- Press SAMPLE to get the sample unit weight
- Press the SCALE/SELECT key to select either SCALE 1 or SCALE 3, be sure to place
the additional pieces on the scale that is selected, it will display the total number of items.
***NOTE: The items being weighed should be within the selected scales capacity.

4.2.2 Select a pre-stored unit weight

Key in the number of the pre-stored weight (01-16) using the numeric key pad, press MEM/READ
key and select the pre-stored sample unit weight, press ENTER to confirm.
4.2.3 High/Low Check Weighing with Counting
-
Turn scale on
- Wait for "0" to appear on the display.
Page 12 of 16
AL-manual-EC200-En-V2