ANZ POS Mobile 2 빠른 참조 매뉴얼 - 페이지 3

{카테고리_이름} ANZ POS Mobile 2에 대한 빠른 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ANZ POS Mobile 2 8 페이지.
ANZ POS Mobile 2에 대해서도 마찬가지입니다: 빠른 참조 매뉴얼 (4 페이지)

ANZ POS Mobile 2 빠른 참조 매뉴얼
LAST TRANSACTION – COPY
1
Press <ENTER> until the 'ANZ EFTPOS MENU' screen appears. Press the <
menu and then press <ENTER> or press the number associated to it to select it.
2
Press <
> key to go to 'COPY' and then press <ENTER> or press the number associated to it to select
'COPY' option.
SETTLEMENT
ANZ Worldline Payment Solutions offers same day settlement, every day.*
1
Press <ENTER> until the 'ANZ EFTPOS MENU' screen is displayed. Press the <
then press <ENTER> or press the number associated to it to select it.
2
Press <
> button until 'SETTLEMENT' is displayed and press <ENTER> or press the associated number to select it
- Select SUB TOTALS by pressing <
Subtotal will be printed. Or
- Select SUMMARY TOTALS by pressing the <
to print Summary total. Terminal will proceed to settlement and settlement receipt will be printed.
*For ANZ business account holders, funds are available on the same day for online transactions, processed through
the terminal and settled before 09:00 pm (AEST). For non-ANZ business account holders, for online transactions
processed through the terminal, ANZ Worldline Payment Solutions will transfer the funds to the merchant's bank on
the following business day and the availability of the funds will be determined by the merchant's bank. For
transactions processed offline or via Paper Merchant Vouchers, these settlement times do not apply.

CHARGING THE TERMINAL BATTERY

Place the base on a clear, flat surface near the mains power outlet.
1
2
Place the terminal on the base by securely connecting the terminal to the docking connector on the base.
3
Connect the base power supply to the base socket as shown below
Example of connecting base power supply to the base socket
1
Connect the other end of base power supply to the main power outlet on the wall.
2
Check that the plug symbol
terminal is connected into the power outlet.
3
Check that the battery symbol

HOW TO LOAD PRINTER PAPER

A red line will appear on the paper, indicating that the paper roll must be replaced. To re-load a new roll:
1
Open the paper compartment by lifting the catch located at the rear of the terminal and pull the cover to the
rear of the terminal.
2
Insert the paper roll (diameter 40mm) in the compartment.
3
Pull the paper up to the top of the terminal and hold in position.
4
Maintain the paper roll position and close the lid.
5
Press the top of the lid in the centre until it clips into position.
Note: do not tamper with or remove the terminal housing.
> button and press <ENTER> or the number associated to it, then
> button and press <ENTER> or the number associated to it
is displayed on the upper right hand side of the terminal screen indicating that the
is flashing or moving on the terminal screen indicating that charging is in progress.
> key to go to "SUPERVISOR"
> key to go to 'REPORT' menu
3