AODELAN FT-8T 사용자 설명서 - 페이지 11

{카테고리_이름} AODELAN FT-8T에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AODELAN FT-8T 13 페이지. Wireless flash trigger

Fire All Channels Switch

1. To fire all flashes or strobes on receivers set to

different channels press the Fire All Button on the

transmitter.

2. The Channel Numbers 1 to 8 will illuminate.

3. All nearby FT-8 receivers set to any channel in

standby mode will fire the connected flashes/

strobes.

4. To turn off Fire All mode press the Fire All Button.

The channel selection will revert to its previous

setting.

Test Button

 The Transmitter Test Button will test fire remote

flashes/strobes.

 To Test: Press the Transmitter Test Button –

flashes/strobes connected to FT-8 receivers on the

same channel will fire.

 The Status LED on the front of the FT-8 transmitter

will flash green approximately every one second

when in standby mode. It will turn red when a

signal is being transmitted.

 The Status LED on the front of the FT-8 receiver

will flash green approximately every one second

when in standby mode. It will turn red when a

signal is received from the transmitter.

 When battery power is low the Status LED on

the transmitter or receiver will quickly flash red

indicating low power and the need to change

batteries.

• 9 •