Abus IPCB42550 사용자 설명서 하드웨어 - 페이지 16
{카테고리_이름} Abus IPCB42550에 대한 사용자 설명서 하드웨어을 온라인으로 검색하거나 PDF를 다운로드하세요. Abus IPCB42550 18 페이지.
페이지 인쇄
3. Connections and functions
3.1 Power supply
ATTENTION!
Before you begin the installation, make sure that the supply voltage and the nominal
voltage of the camera match.
3.2 Call factory default settings (Reset)
1. Please disconnect the camera form power connection.
2. Press the "Reset" button on the camera and keep it pressed.
3. Now connect the power supply to the camera (2-pin power supply or Power over
Ethernet), and hold the "Reset" button pressed for another 30 seconds.
3.3 Switching input/output
The maximum load values must be observed, otherwise, the camera may be
irreparably damaged.
Switching input
Switching output „O"
Description
Connection information
„I"
Bridge between „Alarm In" and „GND"
„GND"
5 VDC ~12 V DC, max. 30 mA, please note the connection
polarity
„GND"
12 VDC, round plug, 5,5 x 2,1 mm
16