3W 112i QS 매뉴얼 - 페이지 11
{카테고리_이름} 3W 112i QS에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3W 112i QS 20 페이지.
페이지 인쇄
Another method that can be used for break in would be to set the engine between 2000-2500 rpm
and let it run for 4 hours. After that the engine would basically be broken in. Note: For break-in a
smaller propeller is recommended.
Important:
Remember that when the engine running ever
person must stay behind the line of the rotating propeller; never to the side or the front!
After Initial Break In
•
Use high grade fully synthetic 2-stroke oil
•
Use the oil manufacturer's recommended gas to oil mixture
•
We use 3W 2-stroke oil in our engines here in Germany, but there are other high grade
2-stroke oils that will perform well. The list below shows some 2-stroke oils that our customers
from abroad have used with success.
Note: The engine needs 12-20 hours running time for the break in process to be 100% complete.
Additional installation notes
•
There must be a minimum 4" separation between anything attached to the receiver and
all things related to the ignition (i.e., the ignition itself, and its wires, battery, and switch)
•
Use a plastic spiral sheath to protect the ignition cables
•
Never remove the sparkplug cap by using a mechanical aid like pliers. Only remove the
cap by hand using a twist/pull movement.
•
The spark plug cap must be firmly seated to the sparkplug. If the spark plug cap is not firmly
seated there is a very good possibility that you will experience radio interference.
112i B4 / QS Engine Manual
Pennzoil at 50-1
Redline at 40-1
Amsoil DOMINATOR Racing Oil at 50-1
Amsoil Saber 100:1 Pre-Mix Oil at 100-1
more infos: www.3w-modellmotoren.com