Danish Care Epi-Care free 사용 설명서 지침 - 페이지 6

{카테고리_이름} Danish Care Epi-Care free에 대한 사용 설명서 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Danish Care Epi-Care free 16 페이지.

Mounting the control unit

The control unit can be placed where convenient in an apartment,

however not more than approximately 10 meters from the bed.

A SIM-card must be

inserted into the SIM-

card slot on the rear

panel of the control

unit.

The card is inserted

correctly with the slanted

corner towards the left.

Press the card fully into

the slot until a "click" is

heard.

The SIM-card enables the control unit to send an alarm call via the cellular network

to the caretaker's phone. The SIM-card has a phone number.

Write this number down and save the information.

If the SIM-card has a PIN code, it MUST be removed before

insertion to the control unit. See troubleshooting on page 14.

The Epi-Care® free will go into error mode, if the PIN code is not removed.

Insert the 12V adapter in a nearby power outlet and insert the adapter's square plug

in the 12VDC socket at the rear-panel of the control unit.

When the control unit is powered up, it will perform a self-test procedure and will then

start searching for the sensor. The text "SENSOR STARTUP" is shown in the

display. As soon as the sensor is connected, the control unit will enter monitoring

mode. This will be signalled by a green light and the text "OK" in the display,

indicating monitoring is working. The control unit shows the sensor's battery state by

a symbol in the display.

When the sensor battery needs charging, the control unit will flash red and audible

sound will indicate the sensor needs to be charged.

When the control unit is powered off, it will send an alarm signal indicating that the

monitoring has ended.