Danish Interpretation Systems DCS 6000 사용자 설명서 - 페이지 4

{카테고리_이름} Danish Interpretation Systems DCS 6000에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Danish Interpretation Systems DCS 6000 14 페이지. Digital conference system
Danish Interpretation Systems DCS 6000에 대해서도 마찬가지입니다: 사용자 설명서 (19 페이지), 사용자 설명서 (10 페이지), 사용자 설명서 (14 페이지), 사용자 설명서 (13 페이지), 사용자 설명서 (18 페이지), 사용자 설명서 (14 페이지)

Danish Interpretation Systems

Important

Compliancy

The equipment has been tested and found to comply
with the limits of the CE test. These limits are
designed to provide reasonable protection against
harmful interference when the equipment is
operated in a commercial environment. The
equipment generates, uses, and can radiate radio
frequency energy and if not installed and used in
accordance with the user manual it may cause
harmful interference to radio communications.
You
are
cautioned
modifications not expressly approved in this manual
could void your authority to operate this equipment.

Main lead wire ring

The wires in the main lead are coloured in
accordance with the following codes:
Green-and-yellow
Blue
Brown
The colours of the wires in the mains lead of this
apparatus may not correspond with the coloured
markings identifying the terminals in your plug, so
please proceed as follows:
The green-and-yellow wire must be connected to
the terminal in the plug marked with the letter E or
with the safety earth symbol or marked with green-
and-yellow colour. The blue wire must be
connected to the terminal marked with the letter N
or marked with black colour. The brown wire must
be connected to the terminal marked with the letter
L or marked with red colour.
The equipment must be connected to earth
4
that
any
changes
Earth
Neutral
Live
Manual 01 18 04452, Printed in Denmark, 02/2003 CHN

Safety

Check that the operating voltage of the unit is
identical with the voltage of your local power
supply. If a voltage conversion is required, consult
your DIS dealer or qualified personnel.
Should any liquid or solid object fall into the
cabinet, unplug the unit and have it checked by
qualified personnel before operating it further.
Unplug the unit from the wall outlet or set the Main
Power switch to OFF if it is not used for several
or
days.
To disconnect the cord, pull it out holding the plug.
Never pull the cord itself.

Installation precautions

Allow adequate air circulation to prevent internal
heat built-up. Do not place the unit on a surface
(rugs, blankets, etc.) that may block the ventilation
holes.
Do not install the unit in a location near heat
sources such as radiators or air ducts, or in a place
exposed to direct sunlight, excessive dust or
humidity, mechanical vibration or shock.
To avoid moisture condensations do not install the
unit where the temperature may rise rapidly.

Cleaning

To keep the cabinet in its original condition,
periodically clean it with a soft cloth. Stubborn
stains may be removed with a cloth lightly
dampened with a mild detergent solution. Never use
organic solvents such as thinners or abrasive
cleaners since these will damage the cabinet.
Operation manual