Danish Interpretation Systems DCS 6000 사용자 설명서 - 페이지 8
{카테고리_이름} Danish Interpretation Systems DCS 6000에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Danish Interpretation Systems DCS 6000 18 페이지. Digital conference system
Danish Interpretation Systems DCS 6000에 대해서도 마찬가지입니다: 사용자 설명서 (19 페이지), 사용자 설명서 (10 페이지), 사용자 설명서 (14 페이지), 사용자 설명서 (14 페이지), 사용자 설명서 (13 페이지), 사용자 설명서 (14 페이지)
페이지 인쇄Danish Interpretation Systems
Front plate controls
q
Incoming Section
•
Volume
This control adjusts the listening level in the
connected headphone
•
Bass
This control adjust the Bass level in the connected
headphone
•
Treble
This control adjust the Treble level in the connected
headphone
•
a-b-c-d
These button selects between four pre-selection of
relay channels
•
Relay-select
These buttons are used for each of the four pre-
selection to scroll through the available languages
•
Floor
This button selects the floor language as the
listening language
q
Outgoing Section
•
Microphone
This button switches on the microphone. When
switched ON, the button and the light ring on the
gooseneck microphone will light red.
•
Mute
This button is used to temporarily switching off the
microphone (when coughing etc). The channel is
still "occupied" when pressing the button, but the
microphone is disconnected as long as the button is
depressed. Mute is indicated by switching off the
light in the light ring of the microphone.
8
Manual 01 18 04445, Printed in Denmark, 02/2003 CHN
•
A
Press this button to select the A-language as the
outgoing channel. A Red LED is indicating, that A-
language is selected. The Yellow engaged LED is
indicating, that the A-channel is occupied i.e. a
microphone on an interpreter set is switched on at
this channel
•
B
Press this button to select the B-language as the
outgoing channel. A Red LED is indicating, that B-
language is selected The Yellow engaged LED is
indicating, that the B-channel is occupied i.e. a
microphone on an interpreter set is switched on at
this channel.
•
B-Select
After pressing the B-button, the B-language can be
selected (if ALL is chosen at the B-mode selection
in the B-language set-up menu.
•
Speaking too fast
Pressing this button sends a signal to the Chairman,
that the Speaker has to slow down his speech.
•
Call
Not implemented
q
Connectors
•
XLR connector
The XLR-connector on the front is used for
connecting a microphone to the unit. Please note
that only DIS series GM40xx and GM44xx can be
used.
•
Headphone connector
On each side of the interpreter set a mini jack is
located for connecting a headphone for listening to
the Floor language or one of the pre-selected relay
languages (a-b-c-d). On the left side a standard jack
connector
is
also
functionality.
User Manual
located
with
the
same