AudioMX HG-31B 사용자 설명서 - 페이지 7

{카테고리_이름} AudioMX HG-31B에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AudioMX HG-31B 10 페이지. Digital over-ear headphones

페이지 인쇄

Notes:

1. For power saving and transmitter protection, the transmitter will automatically switch

to standby mode if there is no audio signal source for approximately 5 minutes (LED on

the transmitter will change to blue). If the audio source signal returns, the transmitter will

automatically switch on (LED on the transmitter will change to orange). Then, power on the

headphones again to listen to music.

2. The headphones will automatically switch off if there is no signal from the transmitter for 5

minutes.

Charging the headphones battery

1. Turn off the headphones by pressing the power button before charging. This may avoid

battery damage.

2. Place the headphones on the top of the transmitter. Make sure the charging pins on the

transmitter and charging contacts of the headphones are matched.

3. The indicator on the transmitter will light in purple during charging process and change

to blue when charging is completed.

Notes:

1. To ensure a longer service life, fully charge the batteries for 7 hours before using the headphones

for the first time. According to the capacity of the rechargeable battery included, the battery

charging process will take approximately 5 hours.

2. Do not charge the batteries over 12 hours. Overcharging may lead to damage of batteries.

Cautions

1. Never attempt to recharge conventional dry cells (batteries).

2. Do no expose the batteries to excessive heat such as direct sunshine, fire or the like.

3. Store the transmitter and headphones in a dry and clean place. Humidity or dust may

cause damage to the inside components.

4. Never use another type of battery or non-rechargeable batteries to replace the

rechargeable batteries supplied.

5. Do not disassemble transmitter or the headphones on your own. It may cause damage.

6. Excessive sound pressure from headphones can cause hearing loss.

Trouble-shooting

Problem

No sound

Distortion

Possible Solution

Make sure the AC / DC adaptor is

fully inserted into the AC outlet and the

power connection input on the transmitter.

Make sure the headphones are switched on.

Headphones battery charging level

maybe too low. Recharge the batteries fully.

Make sure the TV or the connected

audio device is switched On.

The volume of the headphone may be too

low. Adjust the volume to a moderate level.

The audio signal input level is too

Increase the volume of the audio source.

Ensure the volume level of the

headphones is set to an appropriate level.