Abus Terxon MX 설치 지침 매뉴얼 - 페이지 5

{카테고리_이름} Abus Terxon MX에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Abus Terxon MX 15 페이지. Relay board (8x)

Installation

1. Disconnect the alarm centre from the power supply.

2. Terxon SX/MX (connecting cable with two plugs):

Connect the 10-pin plug on the enclosed connecting cable

to the relay board. Connect the connecting cable (12-pin

plug) with the terminal for the additional transistor outputs

(see the Terxon SX/MX installation instructions for more

details). The plug and terminal lock into place when pressed

lightly. The plug only fits in one position (check the imprint

on the plug and terminal).

Terxon LX (connecting cable with one plug):

Connect the 10-pin plug on the enclosed connecting cable

to the relay board. Connect the loose wires on the other side

with one of the available transistor outputs on the alarm

centre (see the Terxon LX installation instructions for more

details).

3. Fasten the four plastic feet (enclosed) to the underside of

the relay board in the four square holes.

4. Connect the relay outputs to the relay board according to

the required switching type (NO (normal open) or NC

(normal closed)) (see FIG2).

5. Fasten the relay board in a suitable position inside the alarm

centre housing using the fixing materials provided.

Technical data

Switch outputs

Maximum switching

power

8x relay NC/NO, potential-free

3 A @ 24 V DC