AudioRealism Bass Line 사용자 설명서 - 페이지 9

{카테고리_이름} AudioRealism Bass Line에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AudioRealism Bass Line 18 페이지. A monophonic programmable synthesizer plug-in

Synthesizer Section

Synthesizer settings are modified by clicking on the switch(es) or knobs and dragging the

mouse. The controls from left to right are:

Waveform - Click the waveform control to toggle between sawtooth and

squarewave. ABL's waveforms are modeled from analog synthesizers and have a

liquid quality to them.

Tuning - The tuning control has a two octave range. To make fine tuning

adjustments, hold down the <Shift> key while adjusting the tuning knob. ABL's

default tuning is set to A-220Hz.

Cutoff - The cutoff control sets the basic cutoff frequency of the VCF. Since the

ABL filter is a low pass filter, all frequencies above the cutoff frequency will be

attenuated. Attenuation can be 18dB/octave or 24dB/octave.

Resonance - Resonance emphasizes certain frequencies around the cutoff point.

This makes the sound brighter and also affects the envelope of the accent.

Envmod - Envelope modulation determines how much movement there should be

in the cutoff frequency. Envelope modulation is bipolar in ABL, thus it modulates

the cutoff positively and negatively with the basic cutoff as center point.

Decay - Decay control sets the speed of the envelope. Turning the knob clockwise

will increase decay time, while turning counterclockwise will shorten the decay

time

Accent - The accent control sets the amount of accent for those steps which have

accent programmed on them. Turning the knob clockwise increases the effect of

accents.

Drive - The knob controls the drive of the signal being fed into the distortion

circuit. This only has any effect if the distortion knob is not fully counter

clockwise.

Distortion - The distortion circuit is activated when the knob is not positioned

fully counterclockwise (in its minimum position). Increasing the distortion will

make the sound harsher. The most 303 like setting is approximately 20%

distortion.

Volume - The volume control simply affects volume. When the volume is set to

75% or more the sound will begin to clip. This is also the nature of the original

Bass Line.

Bass Line – User's Manual