Audiovox 1181277 설치 지침 매뉴얼 - 페이지 6
{카테고리_이름} Audiovox 1181277에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Audiovox 1181277 8 페이지. Chevrolet s-10 blazer overhead console for use with flipdown video system
페이지 인쇄10. Carefully turn console over and secure
O.E.M. console using original screws. Start
all screws before tightening. Caution: Do
not overtighten screws. See Figure 10.
11. Install jumper wire harness (item 8 pg 2) to
extend the red, violet, orange, and black
wires previously cut on O.E.M. harness.
Connect the white wires from video system
light to orange O.E.M. wire. Connect the
black wires from video system light to
black O.E.M. wire. Firmly crimp wires then
slide shrink sleeve over butt connector and
apply heat.
FIGURE 9
9. Carefully insert modified console into vinyl
covered console as shown. Insert the video
system in the opening in center of console.
See Figure 9.
compartment door open to the 90 degree
position until console is installed in
vehicle. This will allow access for
installing screws. If the door is closed
prior to installation in vehicle, it will not
open enough to properly install screws.
CAUTION: The edges of O.E.M. console
may be sharp and could cut the vinyl
console during installation. It may be
necessary to deburr the edge of console
before installation.
6
Note: Leave
FIGURE 10