Audiovox VDS102T 설치 매뉴얼 - 페이지 5
{카테고리_이름} Audiovox VDS102T에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Audiovox VDS102T 13 페이지. Deluxe over-head docking station for dt102
Audiovox VDS102T에 대해서도 마찬가지입니다: 운영 매뉴얼 (16 페이지), 운영 매뉴얼 (16 페이지), 운영 매뉴얼 (16 페이지)
페이지 인쇄
GENERAL INSTALLATION APPROACH:
1) Decide upon system configuration and options that will be installed (i.e.: what components, VCP, Video Game,
external amp, wireless headphones, etc.).
2) Review all manuals to become familiar with electrical requirements and hook ups.
3) Decide upon mounting locations of all components and method of mounting.
4) Prep the vehicle by removing any interior trim necessary to gain access to vehicle's wiring as well as all areas
where interconnecting wire harnesses will need to be located. If any access holes need to be cut into the
vehicle (headliner, other trim components etc.), this should be done now as well. (Refer to Pages 5 & 6)
5) Route the wiring harnesses throughout the vehicle as necessary. (Refer to the Wiring Diagram on page 7
of this manual as well as the wiring instructions for the individual components and accessory options
being installed). Be sure that all wiring is protected from sharp edges and is routed in such a manner that
pinched when all components and interior trim are fully installed. Be sure to leave enough slack in the wiring at
it will not be each component to allow working room.
6) Remove all A/V system components from their packaging and place them loosely in the vehicle at their
respective locations.
7) Connect all components together (electrically) and verify proper operation of all system functions.
Note:
This is best done BEFORE, components have been permanently mounted.
8) After verifying proper operation of the system, proceed to mount of each component.
9) When all components are mounted, recheck function of entire system again to ensure that no wiring was
pinched or connected improperly during final installation.
SYSTEM OPTIONS:
There are a few audio output options that can be added as follows:
a) Wireless Headphones (P/N MVIRHS).
b) Wired relay box for wireless FM Modulator (SIRSWB).
The VDS102T video system is only intended for an overhead, drop down installation. It is
not intended for Seatback or any other type of mounting. The hinging mechanism is designed for
horizontal, drop down use only.
~3~