Audiovox VDS102T 설치 매뉴얼 - 페이지 6

{카테고리_이름} Audiovox VDS102T에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Audiovox VDS102T 13 페이지. Deluxe over-head docking station for dt102
Audiovox VDS102T에 대해서도 마찬가지입니다: 운영 매뉴얼 (16 페이지), 운영 매뉴얼 (16 페이지), 운영 매뉴얼 (16 페이지)

페이지 인쇄
Audiovox VDS102T 설치 매뉴얼

VEHICLE PREPARATION:

1) Locate an accessory power source (+12v when key is in the ACC. and run positions, and 0v when key is
off), and also a good ground generally, these wires can be found at the ignition switch or fuse-box.
2) The mounting method and location will vary from vehicle to vehicle, so this manual will only focus on the
installation of the video monitor and related console accessories.
3) Generally, the best location for the video monitor is where the vehicle's factory dome light is installed. The
monitor should be located in such a manner that it can be comfortably viewed by rear seat passengers.
NEVER INSTALL THE MONITOR IN A PLACE WITHIN THE DRIVER'S VIEW. THIS IS NOT ONLY
DANGEROUS, BUT IT IS ALSO ILLEGAL IN MANY STATES.
4) Once the mounting location of the monitor has been determined, there may be additional preparation work
necessary, depending on the vehicle structure and installation method. Some of the steps that may be
required are:
A) Removal of the vehicle's dome light
B) The headliner may.
C) If the trim ring will be used, it will have to be trimmed to fit the contour of the vehicle's headliner.
Refer to the "trim ring installation" section in this manual.
~4~