Audiovox Sirius Shuttle SIR-CK2 설치 매뉴얼 - 페이지 5

{카테고리_이름} Audiovox Sirius Shuttle SIR-CK2에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Audiovox Sirius Shuttle SIR-CK2 16 페이지. Sirius satellite radio
Audiovox Sirius Shuttle SIR-CK2에 대해서도 마찬가지입니다: 설치 매뉴얼 (16 페이지)

페이지 인쇄
Audiovox Sirius Shuttle SIR-CK2 설치 매뉴얼

Installation/Wiring Precautions

1. To prevent a short-circuit, be sure to turn off the
ignition and remove the negative (-) battery cable
prior to installation. Connect power wires last.
2. Do not install the unit in the locations exposed to
direct sunlight or, in areas subject to extreme
temperatures.
3. Incorrect installation may cause damage to the
system. Mount the unit firmly in place, using
the supplied hardware.
4. Be careful not to damage the vehicle wiring.
5. Be sure to use the supplied screws and washers.
6. Be careful not to snag any wires when tightening
screws.

Setting Up and Installing Your Kit

NOTE: The SIRIUS® signal can be received and
processed virtually anywhere as long as there
are no obvious satellite signal obstructions such
as nearby buildings, high terrain, parking
garages or tunnels.
1. Cabling Interconnections
You can begin to enjoy Sirius® Satellite Radio as soon
as the Shuttle and Vehicle Kit installation are complete.
Set up your Audiovox Shuttle using the following
installation instructions, or enlist the help of a
professional installer:
2. Installing the Cradle Mount Base Assembly
NOTE: The fins on the mounting base are pliable
and can be bent to conform to most
mounting surfaces.
a. Interconnect all of the components as shown
on the adjacent page to verify that the system
operates normally.
b. Locate a firm, reasonably flat surface within your
car to permit optimum viewing and line-of-sight
access by the supplied remote control unit.
-5-