Apollo Xpander XPA-MC-14006-APO 시운전 매뉴얼 - 페이지 3

{카테고리_이름} Apollo Xpander XPA-MC-14006-APO에 대한 시운전 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Apollo Xpander XPA-MC-14006-APO 19 페이지. Diversity loop interface module
Apollo Xpander XPA-MC-14006-APO에 대해서도 마찬가지입니다: 시운전 매뉴얼 (14 페이지)

Apollo Xpander XPA-MC-14006-APO 시운전 매뉴얼

Introduction

XPander incorporates entirely new designs with respect to the wireless communication system. A Radio Interface
is connected to the loop. It communicates with the control panel using the Apollo Addressable two-wire power
and communications system. The interface communicates with the detection and alarm signalling devices by
means of radio waves. A maximum of 5 interfaces is permitted for each site. For sites that require more than 5
interfaces please contact Apollo.
The radio bases and signalling devices are addressable and use a pre-set analogue value to report via the Apollo
protocol. Apart from normal and fire the bases can send pre-set analogue values to indicate low battery, detector
contaminated, detector tamper and low signal strength fault conditions.
Up to 5 interfaces per site - contact Apollo for more information
Up to 31 devices per interface
Loop-powered interface (Including bi-directional Short Circuit Isolator)
Wireless addresses seen by control panel as normal addresses
Radio base with wireless circuitry and battery compartment
Optical chamber designed to inhibit dirt penetration and thus reduce false alarms
Automatic drift compensation with DirtAlert™ warning
Detection algorithms for transient rejection
FasTest™ reduces time taken to test detectors
Remote test facility
5-year battery life (It is recommended that the battery is changed in year 4 of maintenance)
Alkaline Panasonic® Powerline or Alkaline Varta® Industrial are the recommended battery types to use
Modern styling
© Apollo Fire Detectors Limited 2015
3