Apollo XPander XPA-OH-13023-APO 설치 매뉴얼

{카테고리_이름} Apollo XPander XPA-OH-13023-APO에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Apollo XPander XPA-OH-13023-APO 2 페이지. Smoke and heat detectors

페이지 인쇄

Battery Type

6 x AA, 1.5V Alkaline Duracell Procell (MN1500, LR6)

When replacing batteries, allow the device to power down for a period of two minutes

before installing replacements.

Note: When replacement batteries are required all batteries must be replaced together.

Technical Data

Operating voltage

Operating temperature

Apollo Fire Detectors Limited, 36 Brookside Road, Havant, Hampshire, PO9 1JR, UK

Tel: +44 (0) 23 9249 2412 Fax: +44 (0) 23 9249 2754

Email: [email protected] Website: www.apollo-fire.co.uk

39214-394/Issue 3

2.8-5VDC

–10°C to +50°C

XPander Smoke and Heat Detectors

Installation Guide

General

Do not install any XPander equipment until a full site survey has been completed using the

XPander site survey tool. A maximum of 5 interfaces are permitted for each site. For sites

that require more than 5 interfaces please contact Apollo. All installation engineers must

have had certified XPander training.

The XPander smoke and heat detector variants are available under the following part

numbers:

Complete Units

Part Number

XPA-CB-12034-APO

XPA-CB-13032-APO

XPA-CB-11170-APO

XPA-CB-11171-APO

Spares

Part Number

XPA-WB-10022-APO

XPA-OP-12034-APO

XPA-OH-13023-APO

XPA-HT-11170-APO

XPA-HT-11171-APO

The installation must conform to BS5839-1 (or applicable local codes). All detectors are suit-

able for indoor use only.

Description

XPander Optical detector with base

XPander Multisensor detector with base

XPander Heat A1R detector with base

XPander Heat CS detector with base

Description

XPander Mounting base only

XPander Optical head only

XPander Multisensor head only

XPander Heat A1R head only

XPander Heat CS head only