Apollo Enclosures AE5550 설치 매뉴얼 - 페이지 13

{카테고리_이름} Apollo Enclosures AE5550에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Apollo Enclosures AE5550 16 페이지. Environmental tv enclosures (with tv swing brackets) mastering the outdoor tv viewing experience from the inside out

페이지 인쇄

5. Attaching the Back Panel to the Mount

NOTE:

Be sure your mount is completely installed to your outside location and all cables

are run before proceeding.

a. Attach back panel to wall mount, lock the mount in the desired tilt or non-tilt position and tighten tilt

adjustment screws before hanging TV. Refer to directions included with your mount.

b. Run 9' enclosure power cord through rectangular hole in back panel and plug into a GFCI

receptacle with an outdoor rated "in use" cover plate. (See safety statement)

c. Run your signal cable(s) from outside through rectangle opening in rear panel to be hooked up in

next step.

6. Installing the TV to the Back Panel

a. Lift TV and align swing bolts (located on top of TV hanger brackets) above hanger hooks on top of

rear panel and carefully lower into place.

b. Check side to side alignment to be sure TV is centered left to right.

c. Swing bottom of TV outward; plug TV into 3 outlet A/C power receptacle on rear panel and make

appropriate signal connections.

d. To lock TV in place, pull latch cord down, push TV toward bracket and release. Be sure all cables

are clear from interfering with TV swing brackets.

e. Test operation of TV.

IG1902 43-86 Swing A

Attach cable cover, securely tighten into threaded inserts, and

neatly dress all cables using wire cable management covers on

mounts, and wire ties, as necessary.

NOTE: For best results, position cables flat against rear panel.

Page 13