APPA 33II 사용 설명서 - 페이지 13

{카테고리_이름} APPA 33II에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. APPA 33II 16 페이지. Clamp multimeter

3-3 AC Voltage Measurement

1. Set the function switch at " V ~ " position.

2. Connect the black test lead to the "COM" terminal and the red test lead to the " V-Ω" terminal.

You can now place the test probes on the conductors to make the measurement.

3-4 Resistance Measurement

1. Set the function switch at " Ω " position.

2. Connect the black test lead to the "COM" terminal and red test lead to the " V– Ω " terminal.

3. Verify that the power to the circuit under test is off. Connect test leads to the circuit to make the measurement.

4. Built in buzzer sounds if the resistance of the circuit under test is less than approximately 50Ω.