Datamax H-Class 매뉴얼 - 페이지 3

{카테고리_이름} Datamax H-Class에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Datamax H-Class 14 페이지. Cutter option
Datamax H-Class에 대해서도 마찬가지입니다: 매뉴얼 (8 페이지), 빠른 시작 매뉴얼 (12 페이지), 매뉴얼 (10 페이지), 매뉴얼 (12 페이지)

페이지 인쇄

Overview

This document describes the installation and use of the General Purpose Input Output

(GPIO) option for the H-Class printer. After verifying the kit contents and tools needed,

follow the steps to install and begin using the option.

For safety and to avoid equipment damage, turn OFF the power switch and

unplug the AC power cord from the printer before starting this installation.

CAUTION

Contents

This kit contains the following items:

 GPIO Circuit Card Assembly

 Cover Plate

 Screws

Tools Required

To install this option, you will need a Philips screwdriver.

Additional Requirements

Depending on your application, you may need the following hardware to interface the card:



GPI/O A

–

DB15 Male connector (e.g., StarTech C15PCM) and shielded cabling.



GPI/O B

–

High Density DB15 Male VGA connector (e.g., StarTech C15HPSM) and

shielded cabling.

COM C

–

DB9 Male connector (e.g., StarTech C9PSM) and shielded cabling, or a



prefabricated cable (see part numbers and pin out requirements below).



COM D

–

RJ45 Plug (e.g., Belkin R6G088) and shielded cabling, or a prefabricated

cable (see part number and pin out requirements below).