ADE PFA3000 운영 매뉴얼 - 페이지 4

{카테고리_이름} ADE PFA3000에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ADE PFA3000 15 페이지. Electronic precision scale

Your ADE Precision Scale is a quality product.

In order to achieve precise results please kindly read and follow the Operation Manual in all

respects.

Keep this Operating Manual careful to have this information on hand whenever you need it.

 Precision Scale

 Weighing platform

 Power Supply

 RS232-cable (if ordered)

 Windshield dismantled (only model PFA1000)

 Operating Manual including Declaration of Conformity

The power supply is raised either through mains operation by the provided mains adapter 230V

alternating current or through the batteries 6x 1,5V AA (LR6) (not included in this delivery).

a) Mains operation

Connect the supplied mains adapter with the scale. Plug in the pin into the connecting socket

on the backside of the scale housing, which is side next to switch for on and off switching on the

right hand side of the scale.

Connect the mains adapter with the local power supply.

b) Battery operation

Open the battery case at the bottom of the scale.

Insert the batteries (6x 1,5V LR6 – not included in delivery).

As soon as the voltage of the power supply is not enough anymore for operation (less than 5.7V), it

will be indicated by an accordant illustration of a battery symbol

mains adapter must immediately get connected to the local power supply and charged through the

supplied mains adapter.

The batteries should be exchanged against new, unused uniform batteries.

In case the voltage decreases fewer than 5.5 V the scale cannot be used in battery operation.

If the scale will not be used for a longer time please remove the batteries to avoid a damage of the

scale because of possible leaking of batteries.

INSTALLATION AND COMMISSIONING OF THE SCALE

Before connecting the mains adapter, it is essential to control whether

the imprinted voltage value on the adapter corresponds with the local

voltage.

Should the local voltage not correspond with the imprinted value the

scale must not get connect!

in the display and the

PFA-200702-Rev004-UM-en