Austin Hughes CyberView RKP117 사용자 설명서 - 페이지 5
{카테고리_이름} Austin Hughes CyberView RKP117에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Austin Hughes CyberView RKP117 20 페이지. 17”/19” 1u lcd console drawer
Austin Hughes CyberView RKP117에 대해서도 마찬가지입니다: 사용자 설명서 (20 페이지), 사용자 설명서 (18 페이지)
페이지 인쇄
Before Installation
■
It is very important to mount the equipment in a suitable cabinet or on a stable surface.
■
Make sure the place has a good ventilation, is out of direct sunlight, away from sources of excessive
dust, dirt, heat, water, moisture and vibration.
Unpacking
The equipment comes with the standard parts shown in package content. Check and make sure they are
included and in good condition. If anything is missing, or damaged, contact the supplier immediately.
How To Clean Your LCD Monitor
Caution :
■
To avoid the risk of electric shock, make sure your hands are dry before unplugging your monitor from or
plugging your monitor into an electrical outlet.
■
When you clean your monitor, do not press down on the LCD screen. Pressing down on the screen can
scratch or damage your display. Pressure damage is not covered under warranty.
■
Use only cleansers made specifi cally for cleaning monitors and monitor screens. Cleansers not made to
clean monitors and monitor screens can scratch the LCD display or strip off the fi nish.
■
Do not spray any kind of liquid directly onto the screen or case of your monitor. Spraying liquids directly
onto the screen or case can cause damage which is not covered under warranty.
■
Do not use paper towels or abrasive pads to clean your monitor. Using an abrasive pad or any wood based
paper product such as paper towels can scratch your LCD screen.
Cleaning Your Monitor
To clean your LCD safely, please follow these steps :
Disconnect the power cord.
1
Gently wipe the surface using a clean, dry microfi ber cloth. Use as little pressure as possible.
2
Cleaning Tough Marks and Smudges
To remove tough marks and smudges, please follow these steps :
Disconnect the power cord.
1
Spray a small amount of non-abrasive cleanser on a microfi ber cloth.
2
Caution : Do not spray or apply any liquids directly onto the monitor. Always apply the solution to your
microfi ber cloth fi rst, not directly on the parts you are cleaning.
Gently wipe the surface. Use as little pressure as possible.
3
Wait until your monitor is completely dry before plugging it in and powering it up.
4
UM-CV-751-RKP117-Q113V2
www.austin-hughes.com