Austroflamm SmartSpot 사용자 지침 - 페이지 9

{카테고리_이름} Austroflamm SmartSpot에 대한 사용자 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Austroflamm SmartSpot 14 페이지. Room temperature sensor
Austroflamm SmartSpot에 대해서도 마찬가지입니다: 사용자 지침 (20 페이지)

페이지 인쇄
Austroflamm SmartSpot 사용자 지침
SmartSpot
EN

5 | Installing the SmartSpot receiver

5
Installing the SmartSpot receiver
NOTICE
Have the installation carried out by a professional.
When the SmartSpot receiver is being connected to the controls, the stove must be disconnected from
the mains!
The controls are situated behind one of the cladding panels of the stove. Which panel depends upon
the stove model. The corresponding side cladding must be removed beforehand.
The wired room sensor installed as standard on the "T01" connection of the control board must be ter-
minated. (Disconnect the QUICK RELEASE PLUG or remove 2 x black wires from the cable connector)
Then connect the SmartSpot receiver to the controls as follows.
9