Autani ZRB series 사용자 설명서 - 페이지 6

{카테고리_이름} Autani ZRB series에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Autani ZRB series 7 페이지. Zigbee to rs485 bridge

Certifications

5.1

FCC – United State

The ZRB complies with Part 15 of the Federal Communications Commission rules and

regulations. Any modifications to the ZRB may violate the rules of the FCC and make operation

of the module unlawful. FCC ID: V8NZRB1000127.

NOTE 1: This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This equipment

generates, uses, and radiates radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:



Reorient or relocate the receiving antenna.



Increase the separation between the equipment and receiver.



Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.



Consult the dealer or an experienced radio/ TV technician for help.

NOTE 2: The ZRB complies with the FCC RF radiation exposure limits set forth for an

uncontrolled environment. The ZRB must be installed and/or operated with a minimum distance

of 8 in. (20 cm.) between the antenna and people.

NOTE 3: This device complies with part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) This device may not cause harmful interference, and (2) this device

must accept any interference received, including interference that may cause undesired

operation

5.2

IC – Canada

The ZRB is IC certified. IC ID: 7737A-ZRB1000127.

The information contained in this document is proprietary and confidential information of Autani Corporation. Any use of this

information without the expressed written consent of Autani Corporation is prohibited.

ZigBee to RS485 Bridge (ZRB)

Users Manual

CONFIDENTIAL AND PROPRIETARY

6 of 7

5. Certifications