Airwell RC08C 매뉴얼 - 페이지 5

{카테고리_이름} Airwell RC08C에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Airwell RC08C 8 페이지. Room air conditioner remote control

페이지 인쇄

OPERATIION

DEHUMIDIFYING (DRY)

1. Press the ON/OFF (

) button and switch the air condioner ON.

2. Set the MODE selector switch to "DRY"

3. Press the + or - buttons to set the desired temperature (Adjustable temperature

range is 17℃ and 30℃(62-88F)).

Note: You cannot switch the fan speed in AUTO mode, it has been automatically

controlled.

THE DISPLAY SHOWS THE

SELECTED TEMPERATURE.

NOTE

Use DRY operation when you want to reduce the humidity in the room.

Once the room temperature reaches the set level, the unit repeats the cycle of turning on

and off automatically

During DRY operation, the fan speed is automatically set to low or stops to prevent overcooling .

FAN ONLY

If you want to make air circulate without any temperature control, follow these steps:

1. Press the ON/OFF (

) button and switch the air conditioner ON.

2. Set the MODE selector switch to "FAN"

ADJUSTING THE FAN SPEED

AUTOMATIC

Simply set the FAN SPEED selector to the

automatically controls the fan speed when the AUTO mode is selected. When the air

conditioner starts operating, the difference between the room temperature and the set

temperature is detected by the microcomputer which then automatically switches the

fan speed to the most suitable level.

position . A microcomputer

MANUAL

If you want to manually adjust speed just set the FAN SPEED selector as desired.

Each time the button is short pressed, the fan speed is changed in sequence:

4 fan speed setting:

(

(Low)

(High)

(

(Medium)

(

SILENT MODE

To select the silent mode, hold down the Fan Speed button for at least 2 seconds and

then you can switch to the silent mode.

SLEEP MODE

The SLEEP mode enables you to save energy.

1. Set the MODE selector to cool, or heat.

2. Short press the SLEEP/ECO button

3. The mark

appears on the display. Short press the SLEEP/ECO button again

to release the SLEEP function.

What does the SLEEP mode mean ?

In this mode, the air conditioner will cool or heat the room to the set

temperature. After about 1 hour, the air conditioner will automatically reset the

set temperature as follows (also refer to graphs).

OPERATING MODE

Heating

Cooling

OPERATIION

( Auto)

SET TEMPERATURE CHANGE

Lowered by 1 ° C

Raised by 1 ° C